T-T Well

Depending on the depth of the well - a T-T Well Pump may be the best solution for this application

The T-T Well pumps are available in 100G, 125G, 150G, 175G and 200G models

This depends on the flow rate required, depth of the well and the distance to be pumped. With these calculations in place you can then work out which size you need. A rough guide of sizes available can be found here; https://www.ttpumps.com/t-t-well 

If it is well maintained and being used for the application it is intended for, a pump can provide many years of trouble-free pumping 

An irrigation well pump is a well pump being used for irrigation purposes. A well pump is a submersible pump for a hole with a large diameter that is filled with water.

Yes, a well pump can freeze, so check the operating and maintenance manual for information on the minimum and maximum operating temperature range.

Well pumps are normally rated for coninuous operation, although always check the model specific datasheet to be sure.

Well pumps can overheat but cooling is normally provided by the water in the well the pump is submerged in, if you are unsure please speak to our sales department who can advise further.

Well pumps can get clogged, they are designed to handle small bits of grit etc. that may be present in the water in a well and not larger solids.

Well pumps only run in one direction.

No, well pumps are submersible units and do not require priming.

A well pump is unlikely to leak but the pipework it is connected to could leak, it is best this is checked by a suitably mechanically competant person. T-T Pumps has travelling site engineers as well as a workshop at our site that can help with this.

Yes it is possible to move your well pump if required but uninstalling and reinstalling the pump should only be done by a mechanically trained engineer. T-T Pumps has travelling site engineers as well as a workshop at our site that can help with this.

Well pumps do make noise when they run, however due to being down a well it is unlikely that this will be heard from ground level.

Well pumps are normally rated for coninuous operation, although always check the model specific datasheet to be sure.

No, the well pump's motor is made to run off a 230V/1Ph/50Hz electrical supply not a 110V/1Ph/50Hz electrical supply.

A suitably trained electrical person should inspect your control system for the well pump, T-T Pumps has travelling site engineers as well as a workshop at our site that can help with this.

This could be because of a few reasons, either the pump is blocked, there is a leak in the pipework system or the pump has worn. We would advise a competent pump engineer inspect your system, we have travelling site engineers who can look into this for you. Get in touch with our service department on +44 (0) 1630 647200 to arrange a visit.

Your requirement for water and the flow of the well pump will determine the cycle of a well pump, up to and including continous operation. Our sales department can help with bespoke selections including cycle times so please contact us by email or phone.

Our well pumps use an electric motor to rotate the impeller and create centrifugal force that then moves the water from the well to the desired location.

If there is no controls system your well pump will run as long as there is a power supply to the pump and will need someone to stop the power supply to the pump. If there is a controls system this will need to be tested by a electrically competent person to check for faults.

If the pump becomes damaged and stops working at the required duty and it is not cost effective to repair the unit then a replacement becomes the best choice. Our sales department can do bespoke sizing of pumps including replacement well pumps.